Payment & Shipping Terms:
|Wire Dia.:||9 Gauge||Length:||23"|
|Delivery Time:||In 5-15 Days After Receiving Deposit||Payment:||T/T Or Western Union|
23" Precut 9 Gauge Furniture Nosag Springs , Straight Zigzag Springs For Sofa Seat
|Wire Diameter||9 gauge|
|Material||82B or 70#|
|Loop Height||47 - 48mm|
|Loop Width||25 - 26mm|
|Production Capacity||700 tons/month|
|Trade Term||EXW,FOB Guangzhou / Shenzhen,CIF|
|Payment Term||T/T,Western Union|
Springs are an important component of an upholstery system. They have a decisive influence on the comfort of sitting. Based on our long experience we would like to give you some tips how to select the right spring and to check its quality.
One of the most important factors is the correct length of the springs. We would like to explicitly inform you that a spring must be measured “along the arc”. Please pay attention that the spring should be 1 – 3 cm shorter than the inside width of the frame in which it will be assembled.
The springs get their shape retention by a heat treatment at 300° for three hours.
This heat treating has been made correctly if the endings of the springs is blue coloured afterwards.
· Security: rigorous raw material control checks: "High Carbon Steel wire"
· Guarantee: increase the durability of your upholstery furniture
· High recirculation of the air: better stability and support of the weight.
When measuring the required length, it is important to only measure the distance across the area to be bridged with the Serpentine Spring, and not allow for any bowing of the spring which may or may not be required. This measurement will make the difference between the spring fitting perfectly, or sagging or lifting of the cushion. So it needs to be right.
Another factor when using serpentine upholstery springs is the distance between the springs themselves across the chair (or couch). If the gap is too wide, then the cushion will have a tendency to fall down the oversized gap. Conversely, if the gap is too small it may end up either being too strong with little or no ‘spring action’ in it, or simply be too hard to comfortably sit on. Usually a couple of inches gap, (or 50mm) is perfectly adequate. When measuring, please do not allow for the arc, the inside frame measurement is the size required.
1. Pre-sale Service
- Inquiry and consulting support
- Sample testing support
- View our factory
2. After-sale Service
- Give professional advice
- Will be responsible for any product problem or in a damaged condition
Contact Person: Ms.Rae Chou